-
InvillTumma became a registered member 2 weeks, 2 days ago
-
Invillthict became a registered member 2 weeks, 4 days ago
-
Gerardcic became a registered member 3 weeks, 4 days ago
-
RigahitGek became a registered member 3 weeks, 5 days ago
-
Rupertlup became a registered member 2 months ago
-
Wilhemina Boyles became a registered member 2 months, 3 weeks ago
-
Bennie Lilly became a registered member 2 months, 3 weeks ago
-
ThomasJuh became a registered member 3 months ago
-
Christi Legere became a registered member 3 months, 2 weeks ago
-
https://139.162.37.101/'s profile was updated 4 months, 1 week ago
-
https://139.162.37.101/ became a registered member 4 months, 1 week ago
-
Gregorydib became a registered member 4 months, 1 week ago
-
Frankfal became a registered member 4 months, 3 weeks ago
-
NancyAlelt became a registered member 4 months, 3 weeks ago
-
Тимофей Василиса became a registered member 6 months, 3 weeks ago
-
Tuesday posted an update 7 months, 1 week ago
Titanium alloy forging trimming process
Titanium alloy forging trimming must meet the following requirements: (1) The cut is smooth, and the metal on the blank must not fall. (2) The part adjacent to the cut surface of the blank must not be cracked, nor should there be uneven grain size caused by uneven deformation of the cut edge. (3)…[Read more] -
Tuesday became a registered member 7 months, 1 week ago
-
cncmachinings posted an update 7 months, 1 week ago
Machining nitronic 60,T8Mn, T8MnA eutectoid steel: with high hardenability and hardness, but low plasticity and strength. Used to manufacture woodworking tools, hand saw blades, marking tools, rivet dies, clockwork, band saw blades, circular saw blades, coal mine chisels, masonry chisels, etc.
T9, T9A hypereutectoid steel: with higher hardness,…[Read more] -
cncmachinings posted an update 7 months, 1 week ago
Used to make tools with cutting edges that do not heat up during work, tools with sharp edges and a little toughness that do not withstand impact loads, such as tools for processing wood, hand saws, hand wood tools, machine fines Wood tools, twist drills, drawing dies, punching dies, cold heading dies, screw cones, reamer tools, thread rolling…[Read more]
-
cncmachinings posted an update 7 months, 1 week ago
T7, T7A hypoeutectoid steel: has good plasticity, toughness and strength, and a certain hardness, can withstand shock and impact loads, but poor cutting ability. Used to manufacture tools that are not subject to impact load, and require appropriate hardness and wear resistance, and good toughness, such as forging dies, chisels, hammers, punches,…[Read more]
- Load More